Satellites, Vacuum Chambers, Testing, Laboratory
Fuel Cell Development, Cold Chamber testing
Concrete Curing, Ground Thaw, Hot Box Heater
Adhesive Application, Epoxy Transfer, 2-part Spray
EPA-required Testing, Solar, Biofuel Development, Diesel Emissions
Viscosity Control, Production Technology
Emission Testing, Stack Samples, Analyzer Components, Field Tests
International Space Station, Meteorological Analysis
Machinery, Systems Engineering, Semiconductors
Thermal Testing, Non-Condensate, Instrumentation, Electron Microscopes
Flow Control, Instrumentation, Scientific Research, Optical Resolution
Production Machinery, R&D, Test
Train Car Defrost System, Aviation Freeze Protect, Tank Batteries
Mechanical, Chemical, Electrical
Apply heat tape in back-and-forth runs as shown. Leave end loops with adhesive side up.
Press end loops flat, creasing corners at 45° angles.
Apply Heat Transfer Tape across end loops and roll down firmly.
If the heater is permanent and is exposed to moisture, solvents or abuse, tape should be coated with a protective silicone rubber sealant.*.